Installation guide

Page 162 of 206 Maintenance
553-3601-220 Standard 4.00 November 1998
will reset itself, once again detect an inconsistency, and display the
message again.
1. You can restore the card configuration to its original state, then press
RESUME .
2. To keep the new configuration, you must press
RESET . This triggers the
installation procedure. A warning message informs you that all data will
be erased.
Config ambiguous
The Config ambiguous alarm occurs because
• there is one or more empty slots between cards
• a known module has not reported a location
• the system cannot identify a CMBC without at least one powered Base
Station connected to it
• the system cannot identify a CMBC to the right of another CMBC that
does not have at least one powered Base Station connected to it
Correct the problem and press RESUME
.