Installation guide

Page 14 of 206 Installing the hardware
553-3601-220 Standard 4.00 November 1998
Mounting a Base Station
Base Stations can be mounted on a wall or on a ceiling (when mounting on a
wall, install it with the cover at the bottom, as shown in Figure 9 on page 21).
Allow for the following clearance around the Base Station.
Figure 2 : Clearance for the Base Station
Mounting a Base Station
1. Fasten the bracket into position using two 4 mm screws.
2. Route the telephone cable from the distribution block through the top (or
bottom) opening.
3. Wind any excess telephone cable around the posts to secure it, then
fasten it under the strain relief.
4. Connect the cable wires to the BIX connector on the termination board
as shown in Figure 4 on page 15.
27 cm
center
Base Station
cover
bracket mounting
screw hole
bracket mounting
screw hole
9 cm from
other objects
other objects
Bracket
41 cm
9 cm from