Installation guide

Page 30 of 206 Installing the hardware
553-3601-220 Standard 4.00 November 1998
Figure 14 : BIX output connector pinout
4. Connect the dc power pair for each Base Station to the power terminals
on the same connector as in “Upgrading an RPI-8 to an RPI-16.”
WARNING!
Do not power up the RPI until the
installation is complete, including the
installation of Base Station cross-
connectors.
If you are adding extra lines for Base
Stations, always power down the RPI
before you begin.
OBIXn
-PWR(1)
TCM
TCM
+PWR(1)
-PWR(2)
+PWR(2)