Installation guide

System initialization Page 71 of 206
Meridian Companion Installation and Maintenance Guide
Does the display show this message?
Memory Reset
Memory Reset reinitializes the system, erasing any existing system memory
and resetting it to the factory default values.
You must enter the Memory Reset code no later than 15 minutes after the
Meridian Companion system has been powered up. If you enter the Memory
Reset code at any time after the 15-minute interval, you hear an error tone, and
the display shows
Startup denied
. If 15 minutes have elapsed since you
powered up the system, remove and reinsert the CMCC to prepare for Memory
Reset.
Performing Memory Reset
1. Press ƒ , then ••
⁄
. The display shows Password: .
2. Enter the Installer password. The default password is ‚‚‚‚ .
If the password is correct, the display shows
Erase all data?
.
If display shows and the system then
Config Ambiguous
contains CMBC Ensure a Base Station is
connected to the CMBC.
See Table 41 on page 174.
ATTENTION!
Only the installer should perform Memory Reset.
Memory Reset erases all system data and clears all active calls.
The registration information is part of the system data. If this data
is erased, your portables will not work properly.