Installation guide

Page 72 of 206 System initialization
553-3601-220 Standard 4.00 November 1998
If the password is incorrect, the display shows
Password:
. Press
RETRY
and enter the password again.
3. Press
YES
to reset the memory. The display shows
Select Country
.
4. Press
^
.
The display shows the first country selection.
5.
Press
&
or
*
until the desired country is
displayed.
6. Press
OK
. The display shows the country name. Press
OK
to reset the
memory or
CANCEL
to select another country. If
OK
has been selected, the
display shows
Defaults applied
, indicating system initialization has
begun.
7. If you added a Base Station that requires a software update, the system
will begin downloading the software to the Base Station.
a. The Administration Terminal displays
BS-1 Dload Start
. Some
Base Stations may not be powered up at the same time, and this
message will repeat at the beginning of each download. Press
CLEAR
to clear the message. The download may take between 5 to 12
minutes to complete.
b. The Administration Terminal shows
BS-1 Dload Done
when all the
Base Station software is downloaded. Some Base Stations may not
be powered up at the same time, and this message may repeat. Press
CLEAR
to clear the message.
8. Wait for the display to read Re-Eval required, then proceed with
“Programming the Meridian Companion system” on page 73.
ATTENTION!
Memory Reset will erase your system data!
Pressing
Yes
returns all the data in your system to the factory
defaults. To exit with no impact on your system data, press
®
.