Installation guide

Page 78 of 206 Programming the Meridian Companion system
553-3601-220 Standard 4.00 November 1998
2. Enter the Administration password. The default password is
···· (see “Changing the Administration password” on
page 93).
If the password is correct, the display shows
1. Registration .
If the password is incorrect, the display shows Password: . Press RETRY
and enter the password again.
Note: You can also enter an Administration session using the
Configuration password. Once you complete steps 1 and 2 in
“Entering a Configuration programming session” on page 77,
press * then ^ . The display shows
1. Registration .
Ending a programming session
To end Configuration programming or an Administration session, press ®
. The display shows
End of session .
Recording and reporting alarm messages
Alarm messages appear on the display of the Administration Terminal when
the Meridian Companion system generates an alarm. Your Meridian
Companion supplier can interpret these messages to detect problems affecting
system operation. The Administration Terminal must be connected to port 00
on the Controller to receive alarm messages.
This is an example of an alarm message:
See Table 41 on page 174 for other alarm messages.
If an alarm message appears on the Administration Terminal’s
display
1. Record the alarm message in Meridian Companion Programming and
Provisioning Record.
2. Press TIME
and record the time and date displayed.
Alarm:
TIME
51-3
CLEAR