Installation guide

Page 82 of 206 Programming the Meridian Companion system
553-3601-220 Standard 4.00 November 1998
tone is present before transmission. Delay ranges from 200 ms to 2,000 ms, in
200 ms increments, with a default of 1,000 ms.
Changing the Dial delay setting
1. Press ƒ••‚ and enter the Installer password.
2. From A. Configuration , press ^ . The display shows
1. Telephony Data .
3. Press ^ . The display shows Dial delay: followed by the
current delay value.
4. Press CHANGE
until the desired delay value appears.
5. Record the programmed Dial delay in Meridian Companion
Programming and Provisioning Record.
6. Press ® to exit or press * to continue setting telephony
data.
B03 gain value modification
The Meridian Companion system contains digital interconnections that
establish various digital signal paths within the system. There are currently
five paths.
• PBX (Meridian 1) to CPP (Cordless Portable Part)
• CPP (Cordless Portable Part) to PBX (Meridian 1)
• PBX (Meridian 1) to RAD
• RAD to PBX (Meridian 1)
• TONE (DTMF signal generator) to PBX (Meridian 1)
Note: See “List of terms” on page 191 for further explanation of terms.
By default, the gain associated with the paths upon installation is 0. Product
bulletins or other special circumstances may require the installer to adjust the
gain values.
Values are stored in increments of 0.1 dB, although they appear on the display
without decimals. For example, a value of 4.7 dB is stored as 47. A positive