Installation guide

Programming the Meridian Companion system Page 83 of 206
Meridian Companion Installation and Maintenance Guide
value represents a gain; a negative value represents a loss. If a value outside
the valid range is entered, the closest valid value is used.
Adjusting gain values
1. Press ƒ••‚ and enter the Installer password.
2. From A. Configuration, press ^ . The display shows
1. Telephony Data .
3. Press ^ , then * until the display shows
B03 Gain Values .
4. Press ^ . The display shows PBX - CPP: followed by the
current value.
5. Press CHANGE
to enter a new value.
6. Press +/-
to indicate a negative or positive value.
7. Enter the digits. Remember that digits appear without decimal points.
Press BKSP
to make corrections. Press OK when you have entered the
value.
8. Press * to search for the next signal path.
9. Press ® to exit or press * to continue setting programming
features.
Portable telephone side tone
This option enables (you can hear your own voice when using the portable) or
disables (you cannot hear your own voice when using the portable) the side
tone. The default setting at installation is On (side tone enabled). This is the
proper setting for most installations. If required, you can change the setting by
following this procedure:
1. Press ƒ••‚ and enter the Installer password.
2. From A. Configuration , press ^ . The display shows
1. Telephony Data .
3. Press ^ then * until the display shows Side tone: .
4. Press CHANGE
to switch between On (side tone enabled) and Off (side
tone disabled).