Installation guide

Page 84 of 206 Programming the Meridian Companion system
553-3601-220 Standard 4.00 November 1998
5. Press ® to exit or press * to continue setting telephony
data.
CMCC slot
CMCC slot allows you to verify, and if necessary, adjust the card slot address
reported by the Meridian Companion system. Certain system configurations
may require you to adjust the address (value) by applying an offset value.
Contact your distributor if you require additional information about the system
configuration. The display shows the address as
cc xuu
, where
cc
is the card
slot address,
x
indicates the type of adjustment (positive, negative, or
unchanged), and uu is the offset value. If an adjustment is required, upon reset,
the offset is applied to each card slot address as the cards come online.
Changing the CMCC slot address
1. Press ƒ••‚ and enter the Installer password.
2. From A. Configuration , press ^ . The display shows
1. Telephony Data .
3. Press ^ , then * until the display shows CMCC slot:
followed by the slot address.
4. Press * to continue in telephony data if the card address is
correct, or press +
or - until the correct card slot address is displayed.
5. Press APPLY
when the correct address is displayed. The display shows
Warm Reset? .
6. Press RESET
to save the new address and begin a warm reset.
Note: CANCEL
does not save any of the changes and does not initiate a warm
reset.
ATTENTION!
If the card slot address requires an adjustment and you do not
make this adjustment, the WTN addresses will not be consistent
with the M1 addresses.