Installation guide

9-4 Networked systems
Meridian Mail Card Option Release 9.0
3 Plug the modem and terminal into an appropriate AC receptacle and
turn them on.
4 Enter at&f to reset the model to the factory default values.
The screen displays “OK.”
5 Enter at&d3 to enable DTR-initiated reset.
The screen displays “OK.”
6 Enter at&w to save the configuration.
The screen displays “OK.”
7 Turn the modem off, wait ten seconds, and turn the modem on again.
8 Enter at\s to verify the modem settings.
They should read as follows:
For EC2400-33 Rev. 5.2:
\A0, %A0, B0, &C1, \C0, %C1, &D3, \D0, E0, F1, &G0, \G0, \J0,
&L0, M1, &M0, \N1, &P0, Q0, \Q0, &R0, \T0, &T4, V1, \V0, X4,
&X0, \X0, Y0
For EC2400-33 Rev. 6.0:
\A0, %A0, B0, &C1, \C0, %C1, &D3, \D0, E0, F1, &G0, \G0, \J0,
&L0, M1, &M0, \N1, &P0, Q0, \Q0, &R0, \T0, &T4, V1, \V0, X4,
&X0, \X0, Y0, *N0
For EC2400 Plus II Rev.4.53:
\A0, %A0, B0, &C1, \C0, %C1, &D3, \D0, E0, F1, &G0, \G0, \J0,
&L0, M1, &M0, \N1, &P0, Q0, \Q0, &R0, \T0, &T4, V1, \V0, X4,
&X0, \X0, Y0, *N0, #S0, #R0, *B0
If there are any discrepancies, verify the switch settings from step 2 and
repeat steps 4 to 8.
9 Turn off the modem and connect it to the Meridian 1 system according
to the instructions starting on page 9-1.
10 Turn off the terminal and reconnect it to the Meridian 1 PBX.