Installation guide

Terminal configuration 11-9
Installation and Maintenance Standard 3.0 March 1994
Table 11-5
HP700/22 set-up values 11-5
HP700/32 terminals
Table 11-6 on page 11-11 contains the set-up values for the HP700/32 termi-
nal. The set-up procedure is as follows:
1
Turn on the terminal.
2 Press to enter set-up mode.
The current set-up values are displayed on a series of screens.
3 Using the following procedures, change the values on each screen to
match the values in Table 11-6.
General Set-up
Terminal Mode EM200, 7bit Ctrls EM100 ID EM220
On Line YES Interpret Control Mode YES
Columns 80 User Features Locked NO
Smooth Scroll YES User Defined Keys Locked NO
Block Cursor YES Numeric Mode Keypad NO
Cursor OFF NO Normal Mode Cursor Keys YES
Light Background NO National Character Set NO
Inhibit Auto Wrap NO Frame Rate 72
New Line NO Display OFF After (min) 15
Status Line Indicator Multipage NO
Communications Set-up
Host
Xmit Baudrate 1200
(for Sys. Admin. terminal) XON/XOFF @ 64
2400
(for Auxiliary terminals ) Disconnect Delay 2 s
Recv Baudrate =Xmit Stop Bits 1
Data Bits/Parity 8/None Local Echo NO
Check Parity NO Unlimited Xmit NO
Port Selection EIA, Data Leads Only
Printer
Baudrate 9600 Print Mode Normal
Data Bits/Parity 8/None Print Scroll Region NO
Stop Bits 1 Terminator None
Character Set National Only XON/XOFF @ 64
Keyboard Set-up
Keyboard Language North American Data Processing Keys NO
Keyclick YES Shift Lock NO
Margin Bell YES Break YES
Warning Bell YES Auto Repeat YES
Answerback= Auto Answerback NO
Do not set any tabs or programmed keys.