Installation guide

Hardware installation 1-7
Installation and Maintenance Standard 3.0 March 1994
Installing the Meridian Mail cards
The 68k Card connects to the Meridian 1 PBX through the connector at the
back of the Meridian 1 cabinet. One or two DVP Card assemblies and the
Disk/Power Supply Card are connected to the 68k Card through the Connec-
tor Board which plugs in at the front edge of each of these cards.
Due to the force required to install the Connector Board, you should first as-
semble and insert the Meridian Mail cards into the card cage. The card cage
keeps the cards securely in place while you plug in the Connector Board.
Inserting the 68k Card (NTAK14BA)
1 Ensure that the switch on the 68k Card is in the off (down) position.
2 Insert the card into slot 10/MM1 with the solder side to the left and the
components to the right. Do not push it all the way to the back of the cab-
inet and do not lock the latch levers. (Refer to Figure 1-4.)