Installation guide

Hardware installation 1-13

Installation and Maintenance Standard 3.0 March 1994

The final installation

Figure 1-7 shows how to install a three-card Meridian Mail card option sys-

tem into a three-plug Connector Board (NTAK17AA). If the system you are in-

stalling is equipped with a second DVP Card, you will require a four-plug

Connector Board (NTAK17BA).

Note: A four-plug Connector Board can be used with a three-card sys-

tem, but the fourth plug will block slot 9 so that it can’t be used for any

other Option 11 cards.

Ensure that the switch on the 68k Card is in the off (down) position.

2 Moving from left to right, plug the edge of each card into the appropriate

plug on the Connector Board.

Figure 1-7

Installing the Connector Board 1-7

CARD-029