Installation guide

4-14 Basic system procedures
Meridian Mail Card Option Release 9.0
of these features that refers to the old Voice Messaging DN and change it to refer
to the new Voice Messaging DN.
15 Nite call forward (NIT1) in the Customer Data Block may have been pre-
viously set to forward to Meridian Mail. If it was set to the old Voice Mes-
saging DN, change it so that it refers to the new DN. Refer to
Option 11
Technical Reference Guide.
16 Log on to Meridian Mail.
17 From the Main Menu, choose
“3 Voice Administration”→
“3 Voice Services Administration”→
“1 Voice Service DN Table.”
18 Select the Voice Messaging DN and press .
19 Change the value of Access DN to the new Voice Messaging DN and
press
.
20 Return to the Meridian 1 PBX and enable the console and AML data
ports. (Refer to page 4-3.)
21 Start Meridian Mail. (Refer to page 4-6.)
Changing a hardware location DN
1 Log on to the Meridian 1 PBX. (Refer to page 4-1.)
2 Disable the hardware location following the prompts in Table 4-11 on
page 4-21.
3 Change the hardware location’s DN following the prompts in Table 4-13
on page 4-22.
4 Return to Meridian Mail and log on.
5 From the Main Menu, choose
“5 System Status and Maintenance”→
“3 DSP Port Status.”
6 Press and at the prompt enter the number of the DSP port you
want to change.
7 Return to the System Status and Maintenance Menu and choose
“4 Channel Allocation Table.”