Troubleshooting guide

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Computer Removal and Replacement Procedures 7-27
7.12.2 Display Assembly
To remove the display assembly, complete the following procedures:
1. Disconnect the AC power and any external devices (Section 7.4.1).
2. Remove the battery pack (Section 7.4.3).
3. Remove the DualBay device (Section 7.4.4).
4. Remove any PC Cards (Section 7.4.5).
5. Remove the microphone/display cable cover (Section 7.11).
6. Remove the clutch covers (Section 7.12.1).
7. Remove two screws from each clutch and the clutch tension plate that secure the
display to the base enclosure .
8. Disconnect the display cables from the base enclosure .
9. Lift the display assembly from the base enclosure
Figure 7-23. Removing the Display Assembly
Reverse the procedure to replace the display assembly.
CAUTION: To avoid damaging the display and ground cables, attach the ground cable
before attaching the display cables when replacing the display assembly.