User Guide
Table Of Contents
- Contents
- Product Description
- Troubleshooting
- Illustrated Parts Catalog
- Removal and Replacement Preliminaries
- Removal and Replacement Procedures
- 5.1 Serial Number
- 5.2 Disassembly Sequence Chart
- 5.3 Preparing the Computer for Disassembly
- 5.4 Computer Feet
- 5.5 Memory Expansion Board
- 5.6 Mini PCI Communications Board
- 5.7 Disk Cell RTC Battery
- 5.8 Connector Cover
- 5.9 LED Cover
- 5.10 Keyboard
- 5.11 Heat Spreader
- 5.12 Processor
- 5.13 Display
- 5.14 Palm Rest
- 5.15 Diskette Drive
- 5.16 TouchPad Components
- 5.17 Display Release Assembly
- 5.18 Charger Board
- 5.19 Speaker Assembly
- 5.20 Top Cover
- 5.21 Fan
- 5.22 System Board
- 5.23 Modem Cable
- Specifications
- Connector Pin Assignments
- Power Cord Set Requirements
- Screw Listing
- Index
5–32 Maintenance and Service Guide
Removal and Replacement Procedures
4. Remove the TM2.5 × 5.0 screw
1
that secures the display
inverter cable ground loop to the heat spreader (Figure 5-25).
5. Disconnect the display inverter cable
2
from the system
board.
6. Remove the TM2.5 × 5.0 screw
3
that secures the display
video cable ground loop to the heat spreader.
7. Disconnect the display video cable
4
from the system board.
8. Remove the display video cable from the routing channels in
the heat spreader and the top cover
5
.
Figure 5-25. Removing the Display Screws and
Disconnecting the Display Cables
272638-001.book Page 32 Thursday, July 25, 2002 4:21 PM