System information

Security Features 13-15
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Writer: Carey Gregg Saved by: Carey Gregg Saved date: 09/23/98 1:06 PM
Part Number: 316216-003 File name: Ch13.doc
To establish DriveLock protection:
1. Run Computer Setup by turning on or restarting the computer
(Start
Æ
Shut Down
Æ
Restart). When the blinking cursor
appears in the upper-right corner of the screen, press
F10
.
2. Click the System Features icon
Æ
Security Management box
Æ
DriveLock tab.
3. In the Current Drive section, select MultiBay.
4. In the Drive Protection section, click Set to establish
DriveLock protection for the selected hard drive.
5. Read the warning message. If you wish to continue, click OK.
6. In the Set User Password section, enter your new user
password. (You may use up to 32 alphanumeric characters,
and you may use the same password you are using for the
power-on password.)
NOTE:
Type carefully because the password does not display
as you type it.
7. Enter the user password again to verify it.
8. Click OK.
9. In the Set Master Password section, enter your new master
password. (You may use up to 32 alphanumeric characters,
and you may use the same password you are using for the
power-on password.)
NOTE:
Type carefully because the password does not display
as you type it
10. Enter the master password again to verify it.
11. Click OK.
12. Read the warning message. If you wish to establish
DriveLock, type “DriveLock” at the prompt.
13. Click OK.
The changes will take place when Computer Setup has been exited
normally. You will be prompted to enter your user password the
next time you boot your computer using that hard drive.