Specifications

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6-6
Armada MiniStation Removal and Replacement Procedures
6.5 Enclosure Cover
The enclosure cover is spared as a unit. To remove the enclosure cover, follow these
steps:
1. Prepare the Armada MiniStation for disassembly (Section 6.3).
2. Position the Armada MiniStation so the rear panel faces forward.
3. Remove the two screws securing the enclosure cover to the module assembly
1
(Figure 6-6).
4. Grasp the sides of the enclosure cover and swing it up and away
2
until the tabs
on the front of the enclosure cover clear the base assembly. Make sure the docking
lever does not interfere with the removal of the enclosure cover.
Figure 6-6.
Removing the Enclosure Cover
Reverse the removal procedure described above to install the enclosure cover. When
installing the enclosure cover, make sure the alignment pins on the outside edge of the
cover fit into the alignment holes on the upper case.
CAUTION:
When installing the enclosure cover, make sure the right side of the cover fits
inside the docking lever and the left side of the cover does not pinch the power supply
cable. Failure to follow this caution can result in damage to the docking lever and power
supply cable.