Specifications

Power Switch/LED Assembly
1. Prepare the computer for disassembly (Preparation for Disassembly on page 37).
2. Remove the access panel (
Access Panel on page 38).
3. Lay the computer on its side with the front facing toward you.
4. Remove the front bezel (
Front Bezel on page 39).
5. Remove the optical drive (
Removing an Optical Drive on page 55).
6. Disconnect the braided cables from the system board.
7. Remove the cable from the clips in the optical drive cage.
8. Press the tab on the right side of the switch holder (1) to disengage it from the chassis, rotate the
switch to the left (2), and then pull it to the right and away from the chassis while guiding the wires
through the hole in the chassis.
To install the power switch/LED assembly, reverse the removal procedures.
Power Switch/LED Assembly 67