Technical data

4–7
Compaq HSZ80 Array Controller ACS Version 8.3 Maintenance and Service Guide
Reset button blinking;
other LEDs also lit.
Device in error or FAIL
set on corresponding
device port with other
LEDs lit.
SHOW
device FULL Follow repair action.
Cannot set failover to
create dual-redundant
configuration.
Incorrect command
syntax.
See
HSZ80 Array
Controller ACS Version
8.3 Configuration and
CLI Reference Guide
for
the SET FAILOVER
command.
Use the correct command
syntax.
Different software
versions on controllers.
Check software versions
on both controllers.
Update one or both
controllers so that both
controllers are using the
same software version.
Incompatible hardware. Check hardware
versions.
Upgrade controllers so
that they’re using
compatible hardware.
Table 4–1 Troubleshooting Table (Continued)
Symptom Possible Cause Investigation Remedy