Technical data

4–41
Compaq HSZ80 Array Controller ACS Version 8.3 Maintenance and Service Guide
Table 4–7 describes various SET commands that you can enter while running FMU.
These commands remain in effect only as long as the current FMU session remains
active, unless you enter the PERMANENT qualifier—the last entry in Table 4–7.
Table 4–7 FMU SET Commands
Command Result
SET EVENT_LOGGING
SET NOEVENT_LOGGING
enable and disable the spontaneous display of significant events to the
local terminal; preceded by “%EVL.” By default, logging is enabled (SET
EVENT_LOGGING).
When logging is enabled, the controller spontaneously displays
information about the events on the local terminal. Spontaneous event
logging is suspended during the execution of CLI commands and
operation of utilities on a local terminal. Because these events are
spontaneous, logs are not stored by the controller.
SET LAST_FAILURE LOGGING
SET NOLAST_FAILURE LOGGING
enable and disable the spontaneous display of last failure events;
preceded by “%LFL.” By default, logging is enabled (SET LAST_FAILURE
LOGGING).
The controller spontaneously displays information relevant to the sudden
termination of controller operation.
In cases of automatic hardware reset (for example, power failure or
pressing the controller’s reset button), the fault LED log display is
inhibited because automatic resets do not allow sufficient time to
complete the log display.
SET
log_type REPAIR_ACTION
SET
log_type NOREPAIR_ACTION
enable and disable the inclusion of repair action information for event
logging or last-failure logging. By default, repair actions are not displayed
for these log types (SET
log_type NOREPAIR_ACTION). If the display of
repair actions is enabled, the controller displays any of the recommended
repair actions associated with the event.