Technical data

5–39

Compaq HSZ80 Array Controller ACS Version 8.3 Maintenance and Service Guide

03D24402 SCSI bus errors during device operation. The device type is unknown to

the controller. Note that in this instance the Associated Additional Sense

Code and Associated Additional Sense Code Qualifier fields are

undefined.

03D3450A During device initialization, the device reported the SCSI Sense Key NO

SENSE. This indicates that there is no specific sense key information to

be reported for the designated logical unit. This would be the case for a

successful command or a command that received CHECK CONDITION or

COMMAND TERMINATED status because one of the FM, EOM, or ILI bits is

set to one in the sense data flags field.

03D4450A During device initialization, the device reported the SCSI Sense Key

RECOVERED ERROR. This indicates the last command completed

successfully with some recovery action performed by the target.

03D5450A During device initialization, the device reported the SCSI Sense Key NOT

READY. This indicates that the logical unit addressed cannot be

accessed. Operator intervention may be required to correct this

condition.

03D6450A During device initialization, the device reported the SCSI Sense Key

MEDIUM ERROR. This indicates that the command terminated with a

non-recovered error condition that was probably caused by a flaw in the

medium or an error in the recorded data. This sense key may also be

returned if the target is unable to distinguish between a flaw in the

medium and a specific hardware failure (HARDWARE ERROR sense key).

03D7450A During device initialization, the device reported the SCSI Sense Key

HARDWARE ERROR. This indicates that the target detected a non-

recoverable hardware failure (for example, controller failure, device

failure, parity error, etc.) while performing the command or during a self

test.

Table 5–1 Instance Codes (Continued)

Instance Code Description Template