Technical data

5–40 Event Reporting: Templates and Codes
03D8450A During device initialization, the device reported the SCSI Sense Key
ILLEGAL REQUEST. Indicates that there was an illegal parameter in the
command descriptor block or in the additional parameters supplied as
data for some commands (FORMAT UNIT, SEARCH DATA, etc.). If the
target detects an invalid parameter in the command descriptor block,
then it shall terminate the command without altering the medium. If the
target detects an invalid parameter in the additional parameters
supplied as data, then the target may have already altered the medium.
This sense key may also indicate that an invalid IDENTIFY message was
received.
41
03D9450A During device initialization, the device reported the SCSI Sense Key UNIT
ATTENTION. This indicates that the removable medium may have been
changed or the target has been reset.
41
03DA450A During device initialization, the device reported the SCSI Sense Key DATA
PROTECT. This indicates that a command that reads or writes the
medium was attempted on a block that is protected from this operation.
The read or write operation is not performed.
41
03DB450A During device initialization, the device reported the SCSI Sense Key
BLANK CHECK. This indicates that a write-once device encountered
blank medium or format-defined end-of-data indication while reading or
a write-once device encountered a non-blank medium while writing.
41
03DC450A During device initialization, the device reported a SCSI Vendor Specific
Sense Key. This sense key is available for reporting vendor specific
conditions.
41
03DD450A During device initialization, the device reported the SCSI Sense Key
COPY ABORTED. This indicates a COPY, COMPARE, or COPY AND VERIFY
command was aborted due to an error condition on the source device,
the destination device, or both.
41
Table 5–1 Instance Codes (Continued)
Instance Code Description Template