Technical data

5–51
Compaq HSZ80 Array Controller ACS Version 8.3 Maintenance and Service Guide
01082004 The core diagnostics reported a fault.
■ Last Failure Parameter[0] contains the error code value (same as blinking OCP LEDs error
code).
■ Last Failure Parameter[1] contains the address of the fault.
■ Last Failure Parameter[2] contains the actual data value.
■ Last Failure Parameter[3] contains the expected data value.
01090105 An NMI occurred during EXEC$BUGCHECK processing.
■ Last Failure Parameter[0] contains the executive flags value.
■ Last Failure Parameter[1] contains the RIP from the NMI stack.
■ Last Failure Parameter[2] contains the read diagnostic register 0 value.
■ Last Failure Parameter[3] contains the FX Chip CSR value.
■ Last Failure Parameter[4] contains the SIP last failure code value
010D0110 The System Information structure within the System Information Page has been reset to
default settings. The only known cause for this event is an I960 processor hang caused by a
reference to a memory region that is not implemented. When such a hang occurs, controller
modules equipped with inactivity watchdog timer circuitry will spontaneously reboot after the
watchdog timer expires (within seconds of the hang). Controller modules not so equipped will
just hang as indicated by the green LED on the OCP remaining in a steady state.
010E0110 All structures contained in the System Information Page (SIP) and the Last Failure entries have
been reset to their default settings. This is a normal occurrence for the first boot following
manufacture of the controller module and during the transition from one software version to
another if and only if the format of the SIP is different between the two versions. If this event is
reported at any other time, follow the recommended repair action associated with this Last
Failure code.
Table 5–3 Last Failure Codes (Continued)
Code Description