Technical data

5–67
Compaq HSZ80 Array Controller ACS Version 8.3 Maintenance and Service Guide
02F54083 The device saved configuration information selected for the restore process is from an
unsupported controller type. Remove the device with the unsupported information and retry
the operation.
■ Last Failure Parameter [0] contains the disk port.
■ Last Failure Parameter [1] contains the disk target.
■ Last Failure Parameter [2] contains the disk LUN.
02F60103 An invalid modification to the no_interlock VSI flag was attempted.
■ Last Failure Parameter [0] contains the nv_index of the config on which the problem was
found.
■ Last Failure Parameter [1] contains modification flag.
■ Last Failure Parameter [2] contains the current value of the no_interlock flag.
If the modification flag is 1, then an attempt was being made to set the no_interlock flag, and
the no_interlock flag was not clear at the time. If the modification flag is 0, then an attempt
was being made to clear the no_interlock flag, and the no_interlock flag was not set (== 1) at
the time.
02F70100 During boot testing, one or more device ports (SCSI) were found to be bad. Due to a problem in
the SYMBIOS 770 chip, the diagnostic may occasionally fail the port even though the hardware
is OKAY. A reboot should clear up the problem. If the port is actually broken, logic to detect a
loop that repeatedly causes the same bugcheck will cause a halt.
02F80103 An attempt was made to bring a unit online when the cache manager says that a member CLD
was not in the appropriate state.
■ Last Failure Parameter [0] contains the nv_index of the config on which the problem was
found.
■ Last Failure Parameter [1] contains the map type of that config.
■ Last Failure Parameter [2] contains the value from CACHE$CHECK_CID that was not
acceptable.
Table 5–3 Last Failure Codes (Continued)
Code Description