Technical data

5–93
Compaq HSZ80 Array Controller ACS Version 8.3 Maintenance and Service Guide
83020100 An unsupported message type or terminal request was received by the CONFIG virtual terminal
code from the CLI.
83030100 Not all alter_device requests from the CONFIG utility completed within the timeout interval.
84010100 An unsupported message type or terminal request was received by the CLONE virtual terminal
code from the CLI.
85010100 HSUTIL tried to release a facility that wasn’t reserved by HSUTIL.
85020100 HSUTIL tried to change the unit state from MAINTENANCE_MODE to NORMAL but was rejected
because of insufficient resources.
85030100 HSUTIL tried to change the usb unit state from MAINTENANCE_MODE to NORMAL but HSUTIL
never received notification of a successful state change.
85040100 HSUTIL tried to switch the unit state from MAINTENANCE_MODE to NORMAL but was not
successful.
86000020 Controller was forced to restart in order for new code load or patch to take effect.
86010010 The controller code load function is about to update the program card. This requires controller
activity to cease. This code is used to inform the other controller this controller will stop
responding to inter-controller communications during card update. An automatic restart of the
controller at the end of the program card update will cause normal controller activity to
resume.
86020011 The EMU firmware returned a bad status when told to prepare for a code load. Last Failure
Parameter [0] contains the value of the bad status.
Table 5–3 Last Failure Codes (Continued)
Code Description