Technical data

2–25
Compaq HSZ80 Array Controller ACS Version 8.3 Maintenance and Service Guide
Replacing a Controller in a Dual-Redundant
Controller Configuration
Use the following steps in “Removing a Controller in a Dual-Redundant Controller
Configuration” and “Installing a Controller in a Dual-Redundant Controller
Configuration” to replace a controller.
Removing a Controller in a Dual-Redundant Controller
Configuration
Use the following steps to remove a controller:
1. Connect a PC or terminal to the operational controller’s maintenance port. The
controller to which you’re connected is “this controller”; the controller that
you’re removing is the “other controller.”
2. Disable failover and take the controllers out of their dual-redundant configuration
with the following command:
SET NOFAILOVER
3. Remove the program card’s ESD cover and program card. Save them for the
replacement controller.
4. Start FRUTIL with the following command:
RUN FRUTIL
FRUTIL displays the following:
Do you intend to replace this controller’s cache battery? Y/N
5. Enter N(o). FRUTIL displays the FRUTIL Main menu:
FRUTIL Main Menu:
1. Replace or remove a controller or cache module
2. Install a controller or cache module
3. Replace a PVA module
4. Replace an I/O module
5. Exit
Enter choice: 1, 2, 3, 4, or 5 ->