User`s guide

Addding a Second Tape Drive F-7
Compaq Confidential – Need to Know Required
Writer: Everett Godaire Project: TL891 MiniLibary System User's Guide Comments:
Part Number: ER-TL891-UA. A01 File Name: m-appf Addding a Second Tape Drive Last Saved On: 3/1/99 1:26 PM
7. Grasp the handle on top and lift the drive caddy assembly out of the
base module carefully.
8. Set the drive caddy assembly on the work surface and install the
second tape drive as described in Installing the Second Tape Drive.
Replacing
Do these steps to replace the drive caddy assembly in the base module.
CAUTION:
If you’re not careful, you might break the door levers when you set
the drive caddy assembly down in the base module. To prevent this, steady the
assembly as you lower it by the handle so it cannot rock forward as it
approaches the platform, and do not allow the door levers to touch the strut
across the top of the chassis.
1. Grasp the drive caddy assembly by the handle and lower it into
position in the base module; orient it as shown in Figure F-4.
2. Replace the two M4 extension screws (5) at the top of the assembly
3. Coat the threads of the two M4 x 8mm flat-head Phillips screws (4)
with Loctite 222, and replace them on the upper edge of the drive
caddy assembly.
4. Connect the drive 1 and drive 2 RS-422 cables (3) to the controller
PWB.
5. Connect the drive power cable (2) to the power supply connector.
6. Connect the SCSI cable connectors (1) to the controller SCSI extension
cable.
7. Replace the cover plate as described in Removing and Replacing the
Cover Plate.
Installing the Second Tape Drive
Do the following steps to install the second tape drive.
1. Remove the four 6-32 sems pan-head Phillips screws (7) that hold the
blank panel in place in the drive caddy assembly; there are two on the
top of the assembly (Figure F-4) and two on the bottom of the
assembly.
2. Slide the blank panel out of the drive caddy assembly.