System information
Table Of Contents
- Product description
- External component identification
- Illustrated parts catalog
- Removal and replacement procedures
- Preliminary replacement requirements
- Component replacement procedures
- Serial number
- Computer feet
- Battery
- Hard drive
- Optical drive
- WLAN module
- Memory module
- Keyboard
- Top cover
- Speaker assembly
- Power button board
- TouchPad button board
- Modem module
- Bluetooth module
- USB board
- Power connector cable
- Display assembly
- System board
- Optical drive SATA cable and connector
- RTC battery
- Fan/heat sink assembly
- Processor
- Setup Utility
- Specifications
- Backup and recovery
- Connector pin assignments
- Power cord set requirements
- Recycling
- Index
System Configuration menu
NOTE: Some of the listed System Configuration options may not be supported by your computer.
Select To do this
Language Change the Computer Setup language.
Boot options
●
Set an f9, f10, and f12 delay when starting up.
●
Enable/disable CD-ROM boot.
●
Enable/disable floppy boot.
●
Enable/disable internal network adapter boot.
●
Enable/disable MultiBoot, which sets a boot order that
can include most boot devices in the system.
●
Set the Express Boot Popup delay in seconds.
●
Set the boot order.
◦
1st boot device: USB CD-ROM
◦
2nd boot device: USB floppy
◦
3rd boot device: USB SuperDisk
◦
4th boot device: Notebook hard drive
◦
5th boot device: USB hard disk
◦
6th boot device: Network controller
Device Configurations
●
Swap the functions of the fn key and left ctrl key.
●
Enable/disable USB legacy support. When enabled,
USB legacy support allows the following:
◦
Use of a USB keyboard in Computer Setup even
when a your operating system is not running.
◦
Startup from bootable USB devices, including a
hard drive, diskette drive, or optical drive
connected by a USB port to the computer.
●
Enable/disable BIOS DMA data transfers.
●
Enable/disable fan always on while connected to an AC
outlet.
●
Enable/disable data execution prevention.
●
Enable/disable LAN power saving mode.
●
Enable/disable SATA Native Mode.
●
Enable/disable Dual Core CPU.
●
Enable/disable HDD translation mode.
Computer Setup in Linux
103