System information
Table Of Contents
- Product description
- External component identification
- Illustrated parts catalog
- Removal and replacement procedures
- Preliminary replacement requirements
- Component replacement procedures
- Serial number
- Computer feet
- Battery
- Hard drive
- Optical drive
- WLAN module
- Memory module
- Keyboard
- Top cover
- Speaker assembly
- Power button board
- TouchPad button board
- Modem module
- Bluetooth module
- USB board
- Power connector cable
- Display assembly
- System board
- Optical drive SATA cable and connector
- RTC battery
- Fan/heat sink assembly
- Processor
- Setup Utility
- Specifications
- Backup and recovery
- Connector pin assignments
- Power cord set requirements
- Recycling
- Index
9.
Release the ZIF connector to which the power button board cable (4) is connector and disconnect
the cable from the system board.
10. Remove the Phillips PM2.5×6.5 screw (1) from the top cover, disengage the rear edge of the top
cover (2) from the base enclosure, and then remove the cover from the computer (3).
Reverse this procedure to install the switch cover.
60 Chapter 4 Removal and replacement procedures