Operation Manual
Table Of Contents
- Product description
- External component identification
- Illustrated parts catalog
- Removal and replacement procedures
- Setup Utility
- Specifications
- Computer specifications
- 15.4-inch, WXGA, BrightView display specifications
- Hard drive specifications
- DVD±RW and CD-RW SuperMulti Double-Layer Combo Drive specifications
- HD DVD-ROM Drive with SuperMulti DVD±R/RW Double Layer support specifications
- Blu-ray Disc ROM Drive with SuperMulti DVD±R/RW Double-Layer (DL) support specifications
- System DMA specifications, Intel
- System DMA specifications, AMD
- System interrupt specifications, Intel
- System interrupt specifications, AMD
- System I/O address specifications, Intel
- System I/O address specifications, AMD
- System memory map specifications, Intel
- System memory map specifications, AMD
- Screw listing
- Phillips PM2.0×5.0 captive screw
- Phillips PM3.0×3.0 screw
- Phillips PM2.0×3.0 screw
- Phillips PM2.5×7.0 screw
- Phillips PM2.5×10.0 screw
- Phillips PM2.5×4.0 screw
- Phillips PM2.5×3.0 screw
- Hex HM5.0×9.0 standoff
- Phillips PM2.0×2.0 screw
- Phillips PM2.0×7.0 screw
- Phillips PM2.5×5.0 captive screw
- Phillips 2.5×4.0 captive screw
- Backup and recovery
- Connector pin assignments
- Power cord set requirements
- Recycling
- Index
Switch cover
Description Spare part number
Switch cover for use in full-featured computer models (includes LED board and cable) 431425-001 and
451010-001
Switch cover for use in defeatured computer models (includes LED board and cable) 455260-001
Before removing the switch cover, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 41).
Remove the switch cover:
1. Remove the two Phillips PM2.5×10.0 screws (1) and the Phillips PM2.5×4.0 screw (2) that secure
the switch cover to the computer.
2.
Turn the computer display-side up, with the front toward you.
3.
Open the computer as far as possible.
52 Chapter 4 Removal and replacement procedures