User guide

D-4 Compaq Remote Insight Lights-Out Edition User Guide
When the output is not redirected to a log file, the output is paginated (screen-
at-a-time with pause) for ease of viewing. When the output is redirected to a
log file using the /log command line option, only critical (lethal) error
messages will appear on the console and pagination is disabled.
Reset to Factory Defaults
Before configuring specific information to the RILOE board, it is reset to the
factory defaults. Because of this, a single user, “Administrator,” is created
with the default network settings tag password.
Since CPQLODOS 1.0 does not support modifying existing users, and
attempting to add an existing user will cause an error, the user should not
attempt to add “Administrator” in their XML scripting. If you have captured a
configuration file by using the /write_xml command, be sure to delete the
Administrator user from this file before using it to configure a RILOE board.
Minimum Firmware
CPQLODOS is coded to require a minimum firmware level of 2.30 by default.
This can be modified using the command line parameter. CPQLODOS also
requires a SMIF header of at least 2.0 and will not run against old SMIF 1.0
interfaces.
Command Line Parameters
The following sections list the command line parameters available with the
CPQLODOS utility, as well as examples, return messages, and error messages
if applicable.
/help
The /help command displays a simple help message listing available
CPQLODOS commands and return codes. The /? command has the same
functionality.