User guide

Configuring the Remote Insight Lights-Out Edition 4-15
Compaq Confidential Need to Know Required
Writer: James Parish Project: Compaq Remote Insight Lights-Out Edition User Guide Comments:
Part Number: 159206-005 File Name: e-ch4 Configuring the Remote Insight Lights-Out Edition.doc Last Saved On: 7/10/01 4:16 PM
SCO Driver Support
The Remote Insight Lights-Out Edition drivers for both SCO OpenServer
Release 5 and SCO UnixWare 7 are named CRID. These drivers are located
on the SmartStart and Support Software CD. Use the Diskette Builder utility to
create the necessary Extended Feature Supplement (EFS) diskettes for
SCO OpenServer Release 5, SCO UnixWare 7. To install the CRID drivers,
follow the instructions provided on the documentation diskette of the EFS.
IMPORTANT: When using a SCO system, you must install the ATI video controller driver
for correct video operation through the Remote Insight Lights-Out Edition board. This
driver is on the SmartStart and Support Software CD.
Red Hat Linux Driver Support
You can download the SoftPAQ containing the Remote Insight Driver, the
health driver, and agents included in the version 2.31 upgrade for a Linux
system at
ftp.compaq.com/pub/softpaq/sp14001-14500/sp14467.tgz
IMPORTANT: The downloaded file is presented as a compressed file. The file needs to be
expanded using the uncompress utility. The uncompressed file will be identified as
sp14467.tgz. Unpack the file using the following command:
tar xzvf sp14467.tgz
The following section lists the installation process for Red Hat Linux 6.2 and
7.0. These steps assume a new installation. On servers with previously
installed agents and drivers, the agents and drivers must be uninstalled using
the following commands:
rpm -e cpqrid
rpm -e cmanic
rpm -e cmastor
rpm -e cmasvr
rpm -e cmafdtn
rpm -e cpqhealth
rm -fr /opt/compaq
rm -fr /usr/src/redhat/SOURCES/ucd-snmp-4.1.1 for Red Hat Linux 6.2 or
rm -fr /usr/src/redhat/SOURCES/ucd-snmp-4.1.2 for Red Hat Linux 7.0