User guide

Installation
To install the Compaq StorageWorks RAID Array 4000, you will need to:
1. Choose a location.
2. Install the RA4000 in the rack (rack model only) or in the location
chosen for the tower model.
3. Install the hot-pluggable drive(s).
4. Install the Compaq StorageWorks Fibre Channel Storage Hub. Refer to
the documentation supplied with this device for details on installation
and rack mounting.
5. Install the Fibre Host Adapter in an available slot in the server. Refer to
the Compaq StorageWorks Fibre Channel Host Bus Adapter Installation
Guide and the server documentation for details about installing option
boards.
6. Install a GigaBit Interface Converter (GBIC) module in the receptacle
provided at the Fibre Host Adapter and the RA4000 Controller. The
Fibre Channel Storage Hub requires two GBICs-- one for each cable
attached.
7. Connect the Fibre Host Adapter, the RA4000 Controller, and the Fibre
Channel Storage Hub together using appropriate lengths of Fibre
Channel cable.
8. Plug in the power cord(s).
9. Apply power to the equipment in the following order:
a. Fibre Channel Storage Hub
b. RA4000
c. Server
10. Run System ROMPaq and install operating system drivers supporting
the Fibre Host Adapter, using the Compaq SmartStart and Support
Software CD.
11. Run the Array Configuration Utility. (See Chapter 6, “Running the
Array Configuration Utility,” for more information.)