Technical data

Use the update command to update all firmware, or you can designate
a specific device to update; for example, SRM console firmware:
UPD> update srm
___________________ Caution ___________________
Do not abort the update — doing so can cause a corrupt flash
image in a firmware module.
A complete firmware update for a QBB can take from 5
minutes for a PCI with no updatable devices to over 30
minutes for a PCI with many updatable devices. The length
of time increases proportionally with the number of PCI
adapters that you have.
9. After you update the firmware, use the verify command to verify
the firmware update, then transfer control back to the SCM and reset
the system:
P00>>> Esc Esc scm
SCM_E0> reset
10. Set the hard partitions back to the original configuration:
SCM_E0> set hp_count 2
11. At the master SCM, turn system power on:
SCM_E0> power on
12. At the master SCM, transfer control to the SRM console firmware.
Then, using the SRM at the console of each partition, boot the operating
system.
Using GS80, GS160, or GS320 Hard Partitions in a TruCluster Server Configuration 7–21