User's Manual

11
General Hazards
Radiation Hazards
This system can be connected to X-ray generating equipment. Be certain to follow the safety instructions and
specifications for wearing proper lead apron when X-ray exposures are planned or possible.
All personnel should wear protective equipment during all phases of installation, operation and maintenance of
the system.
Electric Shock Hazards
To reduce the electric shock hazard, the system must be connected to an electrical ground. A three conductor AC
power cable is supplied with this system to provide the proper electrical grounding. The power cable must be
plugged into an UL-approved three-contact electrical outlet.
Do not dissemble or modify the product as it may result in fire or electric shock. There are no operator
serviceable parts or adjustments inside the systems. Only trained and qualified personnel should be permitted
access to the internal parts of the system.
Explosion Hazards
Do not operate the equipment in the presence of flammable or explosive liquids, vapors or gases. Do not plug in
or turn on the system where hazardous substances are detected. If flammable substances are detected after the
system has been turned on, do not attempt to turn off the system or unplug it. Evacuate and ventilate the area
before turning the system off.
Implosion Hazards
Do not hit or drop the device. The device may be damaged if it receives a strong jolt, which may result in fire or
electric shock if the device is used without it being repaired.
Owner’s responsibility
The owner is responsible for ensuring that anyone using the system reads and understands the User Manual and
other relevant literature, and fully understands them. BONTECH makes no representation, however, that the act of
reading this manual renders the reader qualified to operate, test and calibrate the system.
Warning(Avertissement)
▩ Do not use the system if unsafe conditions are kwown to exist. In case of hardware failure that could cuase
hazardous conditions (smoke, fire, and etc), turn the power OFF and unplug the power cords of all sub-systems.
▩ N’utilisez pas le système s’il existe des conditions dangereuses. En cas de panne du matériel qui pourrait
causer des conditions dangereuses (fumée, incendie, etc.), éteindre le courant et débrancher les cordons
d'alimentation de tous les sous-systèmes.