User's Manual

43
2. Image Acquisition Section
Sensor Connect
1. Check if Sensor Connect section’s Host PC IP and Sensor IP information is correctly input. Sensor
Connect section on the left side in the middle of the RawImageViewer screen, inside Folder view
(Refer to p.36).
2. Click Serch.
Notice
▩When connection is made succesfully, “Connect success” pop-up appears: when there is no
Detector found nor connection cannot be made, “Connect fail” pop-up appears.
▩ When you fail to connect, check the errors in the following section:
- Network settings: Jumbo Frame and Host IP settings
- Ethernet cable connection status
- Firewall is off.
- Reboot PC and detector.
Image Acquisition
Button Descriptions
Calibration Calibration tools pop up.
Acquisition Acquire images from the detector.
Cancel Cancel when Acquisition is ready.