Specifications

Page 168
S
S
t
t
e
e
p
p
5
5
:
:
From the Start menu, click Run and type cmd. When the command
prompt window appears, type in the following command:
X:\recovery\TFTP -i 192.168.168.1 PUT image_name.IMG, where X refers
to your CD drive and image_name.IMG refers to the firmware filename
found in the Recovery folder of the Product CD.
S
S
t
t
e
e
p
p
6
6
:
:
If you have downloaded a newer firmware and have saved it in your
local hard disk as: C:\accesspoint\accesspointxxx.IMG, then replace the
command with this new path and firmware name. For example:
C:\accesspoint\TFTP –i 192.168.168.1 PUT accesspointxxx.img
The recovery process takes place.
You can monitor the progress of the recovery process with the diagnostic
LED.
When firmware restoration is complete, reboot the access point and it will
be ready to operate.