Specifications
74 en | LCD Keypad Operation SCSI to SATA RAID Subsystem | Administrator’s Manual
F.01U.027.802 | V1 | 2006.11 Bosch Security Systems
5.13 System Functions
Choose “System Functions” in the Main Menu, then press ENT. Press the up or down arrow
keys to select a submenu, then press ENT.
5.13.1 Mute Beeper
When the controller’s beeper has been activated, choose “Mute Beeper," then press ENT to
turn the beeper off temporarily for the current event. The beeper will still activate on the next
event.
5.13.2 Password
Use the controller’s password to protect the system from unauthorized entry. Once the con-
troller’s password is set, regardless of whether the front panel, the RS-232C terminal inter-
face or the RAIDWatch Manager is used, the user can only configure and monitor the RAID
controller by providing the correct password.
Change Password
To set or change the controller password, press the up or down arrow keys to select “Change
Password,” then press ENT.
If the password has previously been set, the controller will ask for the old password first. If
password has not yet been set, the controller will directly ask for the new password. The
password cannot be replaced unless the correct old password is provided.
Press the up or down arrow keys to select a character, then press ENT to move to the next
space. After entering all the characters (alphabetic or numeric), press ENT for two seconds to
confirm. If the password is correct, or there is no preset password, it will ask for the new
password. Enter the password again to confirm.
i
NOTICE!
• The controller requests a password whenever a user is entering the main menu from the
initial screen or a configuration change is made. If the controller is going to be left unat-
tended, the “Password Validation Timeout” should be set to “Always Check.”
• The controller password and controller name share a 32-character space. The maximum
number of characters for a controller password is 32. If 31 characters are used for a con-
troller name, there will be only one character left for the controller password and vice
versa. Since 3.42J09, later firmware revisions will support a 32-character space.