Setup Guide

SkyCamera Trailer Installation &
Setup Guide

Important Note:
This guide ONLY applies to van trailers constructed from Duraplate. Intermodal container installs
should reference the Intermodal Installation & Setup Guide. Trailers with sheet & post construction
are not supported by SkyCamera.

Tools you’ll need:
● Cordless drill (recommended: Power rating of at least 12V)
● 3/16” drill bit
● 1 3/4“ (44mm) hole saw
● Bracket Placement Spacer (PN 190-0035)
● Riveter (rated to be able to pop 3/16 stainless steel rivets)
● 5/32" Pin-in-Hex Security Bit
● Ladder (please follow all OSHA ladder guidelines)
● Recommended: Safety gloves and protective eyewear

Camera placement:
Camera should be installed on the exterior of the container, left side as you look at the door end. The
top of the bracket should be roughly 3” from the top of the container wall and 18 - 36 inches from the
door end. Ensure that when the door is fully open, it does not pinch the camera.