User's Manual

USER MANUAL
86
12. Q: Why doesn’t dynamic detection work?
A: Please check if the motion detection time and motion detection regional setting are correct
and if the sensitivity is set too low.
13. Q: Why doesn’t alarm work?
A: Please check if the alarm settings, alarm connection and alarm input signals are correct.
14. Q: Why does buzzer keep sounding?
A: Please check the alarm settings, check if motion detection function is enabled and if object
motion is detected all the time, be sure to set to Always Off. Otherwise, refer to corresponding
HDD alarm setting.
15. Q: Why can’t I stop recording by pressing “STOP” button or click “Stop Recording” in context
menu?
A: Pressing Stop or Stop Recording can only stop manual record. If you want to stop
Scheduled recording in certain timeframe, please change the setting to No Record. To stop
Startup recording, please change record mode to scheduled recording or manual recording.
Then you may stop recording by the prescribed methods. Another way of stopping recording
is to set channel as off status in record setting.
8.2 Usage Maintenance
1. To shut down your WIRELESS NVR, please shut down the system through the menu and then
turn off the power. Do not turn off the power directly or HDD data will be lost or damaged.
2. Please keep WIRELESS NVR away from heat sources or places.
3. Clean the internal dust regularly. Make sure the good ventilation of WIRELESS NVR so as to
ensure the good heat dissipation.
4. Please check the HDD cable and data cable regularly to see if they are ageing.
5. Please prevent the audio and video signals of WIRELESS NVR from being interfered with by
other electronic devices, and prevent the HDD from being damaged by static electricity and
induced voltage. If the network cable is frequently plugged and unplugged, it is suggested to
replace regularly or the input signal may be unstable.