CE-HDBT100 HDMI/IR/RS232 Twisted Pair over Single Cable Please read this manual carefully before using this product.
HDMI Twisted Pair SAFETY PRECAUTIONS Please read all instructions before attempting to unpack, install or operate this equipment and before connecting the power supply. Please keep the following in mind as you unpack and install this equipment: • Always follow basic safety precaution to reduce the risk of fire, electrical shock and injury to persons. • To prevent fire or shock hazard, do not expose the unit to rain, moisture or install this product near water.
HDMI Twisted Pair Index: 1. 2. 3. 4. 5. 6. 7. 8. 9. General Instruction .................................................................................................................................. 3 Product Picture......................................................................................................................................... 3 Features .............................................................................................................................................
HDMI Twisted Pair · High Bandwidth: 10.2Gps. · HDTV Compatible. HDMI 1.4 and HDCP compliant. · Bi-directional RS232 control. · Bi-directional IR control. · Use HDBaseT technology. · LED indicators show work status. · HDMI cable locking screw nut. · Wall/table-mountable aluminium enclosure, PT case design. · External international power supply (100Volt~240Volt AC, 50/60Hz). 4.
HDMI Twisted Pair Temperature -20 ~ +60℃ Humidity 10% ~ 90% Power Supply 100VAC ~ 240VAC, 50/60Hz Power 6.5W Consumption Case Dimension L134xW77xH30mm L134xW77xH30mm Net Weight 0.8Kg 0.8Kg NOTE: All nominal levels are at ±10%. 5. Function Description 5.1 Transmitter Introduction 1) IR: IR receiver. 2) ON/LINK/IN LED Indicators: All are green LED. ON: Working status indicator of this device. When the device works fine, the LED will keep blinking.
HDMI Twisted Pair 3) 4) 5) 6) 7) 8) 9) LINK: Twisted Pair Link status indicator. It will keep on when connection is successful. IN: When connected with devices support HDCP and work normally this LED will keep on. If devices not support HDCP, the LED will blink. POWER LED: LED indicator of power. When connect with power, red LED will keep on. TP OUT: Single TP cable connects to TP IN port in CE-HDBT100R. HDMI IN: Connect to HDMI source.
HDMI Twisted Pair 3) 4) 5) 6) 7) 8) 9) IN: When connected with devices support HDCP and work normally this LED will keep on. If devices not support HDCP, the LED will blink. POWER LED: LED indicator of power. When connect with power, red LED will keep on. TP IN: Single TP cable connects to TP OUT port in CE-HDBT100T. HDMI OUT: Connect to HDMI display, HDMI signal output. IR IN: Connect with IR receiver, the IR signal received from this port can only send out in CE-HDBT100T.
HDMI Twisted Pair 8.
HDMI Twisted Pair -9-
