Manualshelf

Service manual

ManualsBrandsCOMPRO ManualsTVV220 - START UP GUIDE
31323334353637383940
P-4
06/2005
Error Display Mode
If selection button two is pressed at the “ ” prompt, the controller will enter the Error
Display Mode. If no errors have occurred, the display will show “ ”. If an error has been
detected since the last error reset, the display will show the rst error summary code that
has occurred. If selection button three is pressed while displaying any summary code, the
controller will return to the “ ” prompt.
Note: See the Trouble Shooting section for errors and how to clear them.
EXAMPLE: “ ” would indicate a column jam error in column 1.
Coin Pay Out/Tube Fill Mode
If selection button two is pressed at the “ ” prompt, the controller will enter the Coin
Pay Out Mode. Pressing selection one will scroll through the denominations and pressing
selection button two will start the denomination ashing. The display will indicate the
denomination along with the number of that coin stored in the coin mechanism. If selection
button two is pressed, a pay out of the displayed value will be made. Coins will continue to
pay out as long as that selection button is held down.
EXAMPLE: If selection button two is pressed while 5 cents is displayed it will pay out a
nickel.
When the controller enters the “ ” mode, the operator is allowed to deposit any coin into
the coin changer’s acceptor when that coin’s tube is not full. The tube inventory level will
be displayed after each coin is accepted.
Test Mode
If selection button two is pressed at the “ ” prompt, the controller will enter the Test
Mode where you are able to test the motors, the display, the compressor, the lights, the
evaporator fans and the heater.
Vend Testing
Pressing selection button two at the test mode will enter the controller into the vend test
mode. Upon entry into the vend test mode the display will show the rst summary test,
(column 1). Pressing selection button one will scroll through the column selections.
Pressing selection button two will test vend the displayed column. In order to exit the setting,
press selection button three.
SET-UP AND CODE DESCRIPTION