Service manual

P-7
06/2005
SET-UP AND CODE DESCRIPTION (CONTINUED)
Depth Setting Mode
The purpose of this mode is to enable the controller to set the vending depth for each
column. If selection button two is pressed at the “ ” prompt, the display will indicate “
”. Pressing selection button one will scroll through all of the columns. Pressing selection
button two will enter into the displayed column. Pressing selection button one again will
change the displayed depth settings from 1-4. Pressing selection button two will save the
depth setting and selection button three will exit the mode.
Option Mode
If selection button two is pressed at the “
” prompt, the controller will enter the Option
mode. The purpose of this mode is to allow the controller to select the conguration options
desired.
Display Description Meaning
Force Select Force select enabled (y) or disabled (n)
Bill Escrow Bill Escrow enabled (y) or disabled (n)
Error/Sold Out
Indicator
Error/Sold Out indicator “ ” enabled (y) or
disabled (n)
Single Price Single Price enabled (y)/Multi-Price enabled (n)
Count by Price/Count
by Selection
y = count by price
n = count by selection
Correct Change Light Correct Change Light enabled (y)/Correct
Change Light disabled (n)
Allow Overpay Allow overpay enabled (y)/Allow overpay
disabled (n)
Save Credit Credit will remain for 5 minutes (y)/ Credit will
remain indenitely (n)
Multi Vend Multi vend enabled, single vend disabled (y)/
Single vend enabled, multi vend disabled (n)
Learning Mode* Learning mode enabled (y)/Learning mode
disabled (n)*
Auto MIS reset MIS data will reset with DEX read (y)/MIS data
will not reset with DEX read (n)
FIGURE 2
* The learning mode uses self adaptive logic to “learn” what the depth setting of the column
is, in the event that the control board depth setting isn’t programmed properly.