Service manual

P-14
06/2005
SET-UP AND CODE DESCRIPTION (CONTINUED)
Over-Ride Mode (Units equipped with optional key switch)
This feature is used to allow you to manually over-ride (via a key switch) pricing, blocking,
low energy operation and discounting. If selection button two is pressed at the
prompt, the controller will enter the Over-Ride Mode. Upon entry into this program the
display will show “
”. If selection button one is pressed it will cycle through the over-
ride setting options as listed below. Pressing selection button three will save the currently
displayed setting and return the operator to the “
” prompt.
OVER-RIDE SETTING OPTIONS
Enable/Disable free vend (Edit mode Y/N)
Selection blocking over-ride
Lighting over-ride
Refrigeration over-ride
Discounting over-ride
Over-Ride Free Vend
If selection button two is pressed at the “ ” prompt, the controller will enter the Free
Vend Enable Option. Upon entry into this program the display will show the current setting
“ ”. Press selection button two. Pressing selection button one will toggle between “y” for
enabled and “n” for disable. Pressing selection button two will save the currently displayed
setting. Pressing selection button three will return the operator to the “ ” prompt.
“Y” = Enable free vend.
“N” = Disable free vend.
Over-Ride Selection Blocking
If selection button two is pressed at the “ ” prompt, the controller will enter the Selection
Blocking Over-Ride Enable Option. Upon entry into this program the display will show the
current setting “ ”. Press selection button two. Pressing selection button one will toggle
between “Y” for enable and “N” for disable. Pressing selection button two will save the
currently displayed setting. Pressing selection button three will return the operator to the “
” prompt.
“Y” = Enable selection blocking.
“N” = Disable selection blocking