Service manual

C-2
10/2009
READING A PARTS LIST
I ITEM NUMBER is found in two locations:
 A. Itisonthedrawingplate,andidentiesthepartanditslocation;
B. The same number is in the parts lists and ties the two together.
II PART NUMBER isthepartnumberthathasbeenassignedtoaspecicpartby 
SandenVendoAmerica,Inc.,foreasieridentication.
III QUANTITY REQUIRED relates to the amount required of a part, or will be
 indicatedby“A/R”(asrequired)toattachittoanotherpart.
IV PART NAME AND DESCRIPTION is the general description for the part, for
 easieridenticationwhenorderingalikepart.
V HARDWAREisidentiedbyaletterinahexagon.Refertohardwarelistsection
or description and part numbers. See pages C-4 and C-5.
Theexamplebelowwillshowhowthepartsarelistedinthepartslists:
1. VEND MOTOR ASSEMBLY: Thisisthemainassemblyname,andany 
 replaceablepartswillbeindentedbelowtheassembly.
2. RETAINER CAM: This is an individual part, and will be indented. These indented
 partscanbeorderedseparately,soyoudonotneedtoordertheentireassembly.
3. Wheneveranassemblyisordered,allthepartsthatareindentedwillbeincluded
 intheassembly.Anyhardwarewillbelistednexttotheircorrespondingparts.
4. Anypartsthatmaybeorderedseparatelywillnothaveanyindentedpartslisted
below them.
Ifanasteriskislistedbelowthepartslist,itisanindicationthatspecialinformationis
noted.Theremaybemorethanoneasterisk(*)(**)(***)denotingspecialnotes.
ITEM
NO
DESCRIPTION QTY
REQ
PARTNO.
1 VENDMOTORASSEMBLY ~ 1115821
2 RETAINERCAM 1 1113244
3 TIMING CAM 1 1113236