Service manual

READING A PARTS LIST
I ITEM NUMBER is found in two locations:
A. It is on the drawing plate, and identifies the part and its location;
B. The same number is in the parts lists and ties the two together.
II PART NUMBER is the part number that has been assigned to a specific part
by Vendo, for easier identification.
III QUANTITY REQUIRED relates to the amount required of a part, or will be
indicated by “A/R” (as required) to attach it to another part.
IV PART NAME AND DESCRIPTION is the general description for the part, for
easier identification when ordering a like part.
V HARDWARE is identified by a letter in a hexagon. Refer to hardware list section for
description and part numbers. See pages C-4 and C-5.
The example below will show how the parts are listed in the parts lists:
1. VEND MOTOR ASSEMBLY: This is the main assembly name, and any
replaceable parts will be indented below the assembly.
2. RETAINER CAM: This is an individual part, and will be indented. These
indented parts can be ordered separately, so you do not need to order the entire
assembly.
3. Whenever an assembly is ordered, all the parts that are indented will be included
in the assembly. Any hardware will be listed next to their corresponding parts.
4. Any parts that may be ordered separately will not have any indented parts listed
below them.
V-MAX VEND MOTOR ASSEMBLY
ITEM NO. DESCRIPTION QTY REQ PART NO.
1 VEND MOTOR ASSEMBLY - 1115821
2 RETAINER CAM 1 1113244
3 TIMING CAM 1 1113236
4
If an asterisk is listed below the parts list, it is an indication that special information is
noted. There may be more than one asterisk (*) (**) (***) denoting special notes.
3/2002
C-3