User's Manual

Tablet Blue TW 10 Series

Bogotá Colombia 17

However, depending on the amount of RAM that has been installed on your

Tablet, the amount of time the system requires to restore all its previous

contents can range from five to 20 seconds.

Power button action.

The Tablet power button can be set to turn off the system or activate the

suspend mode under an environment of operating systems.

Sleep mode (sleep).

Defined as the state of derating used by the computer or monitor after

entering or moving to a period of inactivity (To monitor these signals are

given by the computer). In practice, the computer keeps on consuming less

energy and with the monitor in black. This mode is deactivated when it

receives a signal from the mouse or keyboard.

Standby mode (off).

Defined as a state of "off" on tablets energy consumption (passive power)

as still connected to the mains. In practice the tablet is off, but consumes

very little power. It has two modes, one in which all programs are closed

and relight the tablets returns zero and the hibernation state in which is

stored on the hard disk the current state of Windows, that is, when you turn

on the tablet again It lights up with programs and windows that were active.

To activate these energy saving modes follow the instructions presented

below. If you cannot do this, ask your network administrator computer that

you configure this mode. Remember that there are several combinations

for configuration and energy saving, select the one best suits you.

The Power System Battery.

Before using the computer on battery 1st time, check the status icon battery

in the Toolbar Windows or Linux to make sure the battery is fully charged.

See Battery Status later in this section for a description and explanation of

the Windows Battery icon. Charging the battery takes about 2.5 hours when

the system is off. If possible, always charge the battery completely.

NOTE:

If you use the battery so frequently that it exceeds more than 20

times with download / upload completely in one month, we

recommend performing the process "Battery Calibration" every 3

months to maintain battery life.