Instruction manual

20
adjustment mode. This function helps to correct printout alignment problems.
Resume factory default settings
Hold down Shift button and Ready button simultaneously, and turn on the
printer. After a long beep, the printer resumes factory default setting.
EDS (Electronic Dip Switches) setting
While holding down Shift button and Font button simultaneously, turn on the
printer. The printer enters into EDS setting mode. Refer to the “How to change
the EDS settings” below, and change the parameter settings of the printer.
Configuring the Printer
The EDS setting can execute different functions by changing default power-on
parameters. The EDS setting options can be selected through software
commands or by using the operator panel buttons.
The part below shows all the options of EDS in detail. Refer to the “how to
change the EDS settings” for the alteration guidance about the EDS setting.
Latin EDS Settings Options
The following table shows all the function options and relative parameter
settings available in Latin EDS settings. The factory default values are shown in
Bold.
Function Option Settings
Buffer Size 128k, 0k
Emulation ESC/PK, AR, OKI
Copy Capability Normal, Copy
Auto CR/LF CR,LF+
CR
, CR,LF, CR+
LF
,LF, CR
+LF
,LF
+CR
Please note that the present rear DIP switch has no use. The further
upgrade about its function may be subject to the F/W version.