Instruction manual

27
1. Make sure that the paper has been set to the tear-off position.
2. Hold down the Shift button while pressing the LF/FF button to adjust the
position forward.
Hold down the Shift button while pressing the LOAD/EJECT button to
adjust the position backward.
Note: The newly set tear-off position is automatically saved.
3. Tear off the printed continuous paper.
4. When the printer resumes printing, it will feed the continuous paper to the
loading position automatically before printing.
Paper Path Selection
There are three paper paths designed for this type of printer: front-in, rear-in
and bottom-in, so that the tractor can be set to suit different kinds of paper.
Set the path selection lever correctly to choose the right paper path.
There is a limit (maximum and minimum) for the tear-off position. If you
exceed the limitation during adjustment, the printer beeps and stops
adjustment.
During the adjustment, if the adjusted value meets the factory default
value, the printer beeps and stops for a moment. Please base your
adjustment on the manufactory default value.